TVB-161 20 inches 508mm VATBAND ONLY

$21.95
ThermalVATBAND is a simple as adhesive tape that applied to a 3D resin printer VAT will maintain an ideal temperature for your photopolymer resin, despite the ambient temperature. ThermalVATBAND regulates temperature using thermostats  that can be easily be attached and are safe to the touch. Using ThermalVATBAND is efficient and cost effective, costing $.85 per 24hr compared to $4.50 per 24hr for typical 120V conventional heaters.      

TVB-M3 Magnetic-LED is 34 inches 860mm VATBAND ONLY

$66.95

The Thermalvatband measures 33 inches by 1 inch (83.82 centimeters) and features a NEW magnetic quick-release mechanism. This allows you to easily detach the vat without the need to unplug the power. Additionally, we have enhanced the metal filament size to improve conductivity for faster performance. The magnetic power contact reduces the risk of arcing, providing added safety and efficiency. - Includes an accessory pack (sticker over the VATBAND and an extra sticker for the thermostat (aluminum tape), a thermometer, and a scuff pad to clean the VAT before application. All VATBANDS are compatible with older versions of power adapter and including 5A adapter.
- You may have to place a 1/8-inch diameter hole in the back of your case to allow power access.

TVB-M3 MAGNETIC-LED KIT WITH POWER ADAPTER

$74.31

The Thermalvatband measures 34 inches by 1 inch 864mm and features a NEW magnetic quick-release mechanism. This allows you to easily detach the vat without the need to unplug the power. Additionally, we have enhanced the metal filament size to improve conductivity for faster performance. The magnetic power contact reduces the risk of arcing, providing added safety and efficiency. - Includes an accessory pack (sticker over the VATBAND and an extra sticker for the thermostat (aluminum tape), a thermometer, and a scuff pad to clean the VAT before application. Backwards compatible with all VATBAND power adapter.
- You may have to place a 1/8-inch diameter hole in the back of your case to allow power access.

TVB-V2 20 INCHES NO POWER ADAPTER

$42.35
Thermalvatband 20 inches by 1 inches ( 50.8 centemeters) with connection bay 3 ( 2.5 centemeters) - Includes accessories pack ( sticker over VATBAND and extra sticker for thermostat (aluminum tape) thermometer and scuff pad to clean VAT before appication. Ideal for printers: Saturn S, Mono X all medium and small VATS.

TVB-V2 20 INCHES POWER ADAPTER INCLUDED

$49.67
ThermalVATBAND band that is 20 inches long and 1 inch wide, with a direct female jack connection in a low-profile box on the VATBAND itself. The TVB-161 appears to have wires hanging from the VAT and a female jack at the end of the wire. It's possible to split the power source of the thermal VAT band and share it with another VAT band or a bottle warmer, allowing up to three products to be powered at the same time. - Includes accessories pack ( sticker over VATBAND and thermostat sticker that can be applied directly on TVB (consider the fact that the temperature will be higher outside versus the resin inside by approximately 5 degrees). Aluminum tape is placed on stress points on curves and edges, and after pulling the jack area, a strip is applied to the cold zone on the front and back of the box. Before applying the VAT, use a scuff pad aggressively clean the VAT surface with IPA to remove any remaining resin.