TVB-V2 20 INCHES POWER ADAPTER INCLUDED
ThermalVATBAND band that is 20 inches long and 1 inch wide, with a direct female jack connection in a low-profile box on the VATBAND itself. The TVB-161 appears to have wires hanging from the VAT and a female jack at the end of the wire. It's possible to split the power source of the thermal VAT band and share it with another VAT band or a bottle warmer, allowing up to three products to be powered at the same time.
- Includes accessories pack ( sticker over VATBAND and thermostat sticker that can be applied directly on TVB (consider the fact that the temperature will be higher outside versus the resin inside by approximately 5 degrees). Aluminum tape is placed on stress points on curves and edges, and after pulling the jack area, a strip is applied to the cold zone on the front and back of the box. Before applying the VAT, use a scuff pad aggressively clean the VAT surface with IPA to remove any remaining resin.
Select options
This product has multiple variants. The options may be chosen on the product page
Magnetic-LED M2 with 20in – 508mm kit includes with power adapter
The latest version of your VATBAND now includes an LED light power indicator and improved features such as a larger contact point and a stronger magnet. The previous 360-degree pivoting male head has been replaced with a solid core direct contact for enhanced durability during daily use. The VATBAND is 20 inches long and 1 inch wide, and it still uses the same power supply and connection that is compatible with all versions.
Kit icludes everything you need to get started. It's possible to split the power source of the ThermalVATBAND band and share it with another VAT band or a bottle warmer, allowing up to two products to be powered at the same time.
- Includes accessories pack ( sticker over VATBAND and thermostat sticker that can be applied directly on TVB (consider the fact that the temperature will be higher outside versus the resin inside by approximately 5 degrees). Aluminum tape is placed on stress points on curves and edges. The connection point is at the cold zone. Before applying the VAT, use a scuff pad aggressively clean the VAT surface with IPA to remove any remaining resin. You can add a HVAC aluminum tape on the vatband before the top sticker supplied. Be mindful of avoiding gaps on tight curves, as aluminum tape can provide additional support. Good contact is essential for efficient heat conduction and electrical conductivity to prevent hot spots and discoloration.
Select options
This product has multiple variants. The options may be chosen on the product page
