TVB-V3 34 inches VATBAND ONLY
Thermalvatband is 32 inches by 1 inch (81.28 centimeters) with a revised direct connect to power adapter. Increasing reaction time and heat by 10%. The advantage to a direct connection is resin drips will not cause any issue with contact points.
- Includes an accessory pack (sticker over the VATBAND and an extra sticker for the thermostat (aluminum tape), a thermometer, and a scuff pad to clean the VAT before application.
- You may have to place a 1/8-inch diameter hole in the back of your case to allow power access.
UV WAND – Perfect for Curing Inside Hollow Prints
The UV Wand was inspired by customers like you who asked for a solution to cure the inside of hollow prints. Even after an IPA wash, uncured resin remains in a caustic state, gradually eroding the inner surface walls. Over time, this can lead to surface tension cracks on the top layer, compromising the integrity of your print. We recommend the inner walls to be 4mm thick without any supported mesh inside the hollow cavity it doesn't really do anything accept trap more resin. Your drain holes being 5mm and your air holes close enough to place both end of the wand into the cavity area. Leave it in as long as you can, move the wand different layers and positions it can cure area of 30mm diameter area at a time. so do move the wand different locations of the hollowed model to get every area cured.
Liquid Metal Resin
All metals aren't created equal each have their own limitations when it comes to chroma or saturation level. This means that the intensity or vividness of the color achieved with a particular metal powder may have a maximum limit.
Regarding the exothermic reaction, it seems that the metal powder increases the release of heat during the reaction. As a result, it is important to take precautions when storing the product containing the metal powder. If the bottle is stored outside of its packaging, it should not be exposed to temperatures exceeding 28°C. However, if the bottle is wrapped in insulation as part of the package, it can help mitigate the effects of external temperature and provide some protection for the product.
Plug extension with switch
SPLITTER-2
Connect one power source to 2 or 3 3D resin printers using a splitter. To get the most out of your power source we have provided you with our lage format 12V3A power supply that will power 2 MONO X medium size 3D printers using the 2 splitter or 3 small format Mars, photon or Sonic Mini 4k 3D resin printers with a 3 way splitter.
THERMAL BOTTLE WRAP WITH POWER SUPPLY
Select options
This product has multiple variants. The options may be chosen on the product page
